MultiPort Plug Valve - Series 604

  • Valves up to and including DN200 are supplied with a 50mm square drive for use with optional removable levers
  • Gear or actuator operation is available
  • Internally epoxy coated
  • Elastomer faced plug
  • Flanges drilled to BS EN 1092 PN16
  • Variety of flange drillings available
  • Nitrile faced plug
  • Optional Neoprene faced plug
  • Flange drillings: PN10, PN16, ANSI

Applications

Water Industrial

1 Body

Valve body casting uses pressure moulding techniques for consistent quality and precision. Flange diameter and thickness conform to ANSI B 16.1 Class 125. Flange drillings PN10, PN16, ANSI

2 Seat

The Multiport valve employs a corrosion and abrasion resistant epoxy seat on all sizes

3 Stem Seal

Multiple self-adjusting “U” cup seals are used to prevent stem leakage and provide years of trouble free service

4 Bearings

The plug rotates in oil impregnated sintered 316 grade stainless steel bearings located in both the body and bonnet

5 Plug

supported on integral trunnions, the solid ductile iron tapered plug is faced with any of a variety of elastomers that are vulcanized in place and ground to size. Plug position and shut off is controlled by use of adjustment gland attached to the plug shaft

6 Bonnet Seal

Superior ‘O’ ring sealing with metal/metal contact means lower stresses compared to traditional compression gaskets

7 Flow

The wide port design with streamlined internal contours allows for a high capacity flow in the full open position reducing turbulence and pressure drop through the valve

8 Position Indication

Active port indication is standard on all wrench operated and gear operated millcentric Multiport valves

Select your language

  • DR9380 MULTIPORT VALVE VJ BRO THUMBNAIL 0917

    MultiPort Plug Valve Brochure

    For Flow Diversion Applications

    Download

Data Sheets